BS 7593 cleaning methods
Powerflush, mains and gravity cleaning explained
BS 7593 describes three ways to clean and flush a domestic heating system. Here is how each works in general terms, so you can understand what your installer proposes and ask sensible questions about it.
The three methods in BS 7593
BS 7593 is the British Standard code of practice for preparing, commissioning and maintaining domestic central heating water systems. When it comes to cleaning, it does not prescribe a single technique. It sets out three:
BS 7593 describes three cleaning and flushing methods: powerflushing (external pump and tank), mains pressure cleaning, and gravity cleaning (using the system's own circulating pump).
All three share the same goal: loosen and remove sludge, magnetite and debris so the system can be refilled with clean, treated water before the heat pump is connected. They differ in how the water is moved and where the dirty water goes. The general descriptions below are for understanding only; the detailed procedure is in the standard and the installer’s own training.
Powerflushing
In a powerflush, an external pump and tank are connected to the heating system. The external pump circulates water, usually with a cleaning chemical, around the system. Radiators are typically worked through in turn so that each one is cleaned, and the dirty water is then flushed out and replaced with clean water.
You will see “powerflush” used loosely as a catch-all for any system clean. It is worth asking whether that is really what is meant, because it is one specific method among three.
Mains pressure cleaning
Mains pressure cleaning uses the pressure of the incoming mains water to push water through the system and out to a drain. Sections of the system can be flushed in turn, with the dirty water leaving the system rather than being recirculated. Whether this method suits a home depends on the property and its system, which the installer will assess.
Gravity cleaning
Gravity cleaning uses the system’s own circulating pump rather than an external one. Cleaning chemicals are circulated through the system, and the system is then drained and refilled to remove the loosened material. Because it uses the existing equipment, it involves less extra kit on site.
Which method is best?
The honest answer is that it depends on the system, and the sources this site relies on do not declare one method the winner. Factors an installer may weigh include the age and condition of the system, the type of system, access to radiators and pipework, and what they find when they assess the water.
What matters to you as a homeowner is that a recognised BS 7593 method is used, that the installer can explain their choice, and that the work is recorded. Industry commissioning paperwork includes a line for exactly this:
The Heat Pump Association's air source heat pump commissioning checklist asks the installer to confirm "System Flushed & Cleansed (as BS 7593)", "System purged of air", inhibitor added and an in-line filter fitted.
You can read more about how cleaning fits into commissioning on our BS 7593 and MIS 3005 page.
Questions to ask your installer
- Which of the three BS 7593 methods will you use on my system?
- Why is that method suitable here?
- Will the system be cleaned and flushed before the heat pump is connected, not afterwards?
- What cleaning chemical and inhibitor will be used?
- Where will the in-line filter go, and how do I look after it?
- Will the cleaning appear on the commissioning record I receive?
Always check the heat pump manufacturer’s installation manual and warranty terms for their water-quality requirements, and ask the installer to confirm they will be met. If any term on this page is unfamiliar, the glossary has short definitions, and the system cleaning guide explains why this step comes first.
Sources
Last reviewed: . Checked against the sources listed on this page; this is not an independent technical or professional review.
Keep reading
Before anything is connected