Step 1Symptoms
Pressure and air problems often appear together. Look for:
- The pressure gauge reading falling over days or weeks.
- Low pressure warnings or lockouts on the controller.
- Gurgling, trickling or rushing sounds in pipes and radiators.
- Radiators cold at the top that need bleeding repeatedly.
- Damp patches, stains or drips near pipework, valves or radiators.
Step 2Likely causes
Pressure loss usually means water is escaping somewhere: a weeping valve, a radiator joint, a pressure relief valve discharging, or a leak hidden under floors. An expansion vessel that has lost its charge can also cause pressure to swing up and down and the relief valve to release water.
Air gets into systems through small leaks, during refilling, and from gas produced when corrosion is active inside the system. Persistent air is sometimes a sign of ongoing corrosion, which is also what produces magnetite sludge. Heat pump systems often include an automatic air vent or an air and dirt separator to remove air continually, and if these are missing, blocked or poorly placed, air can linger.
Pressure naturally rises a little as the system heats up and falls back as it cools, so some movement on the gauge through the day is normal. What matters is the trend over several days at the same time of day. A steady fall, or regular large swings, deserves attention.
Step 3What a homeowner can safely check
These checks are safe. Do not open the heat pump or adjust the expansion vessel or relief valve.
- Note the pressure reading at the same time each day for a week.
- Look along visible pipework and under radiators for drips, stains or crusty white deposits.
- Check outside where the relief valve discharge pipe ends for signs of water.
- Bleed radiators that are cold at the top, following your installer's guidance, then recheck the pressure.
- Only top up pressure if your installer has shown you how and to what level.
Step 4When to call a professional
Call an engineer if you need to top up more than occasionally, if the relief valve is discharging, if you find a leak, or if air keeps returning. Recharging an expansion vessel, finding hidden leaks and checking air separation are engineer tasks. Where repeated air points to corrosion, the engineer may recommend water testing and a clean, followed by correctly dosed inhibitor.
Keep your pressure log and any photos of damp patches to show the engineer. Small leaks are often intermittent, and evidence of when and where they appear makes them much quicker to find.
Step 5How prevention helps
Cleaning the system before the heat pump goes in removes the corrosion debris that clogs air vents and separators, and gives a chance to spot weak valves and joints while the system is drained and worked on. Starting with clean water also makes inhibitor protection more effective. Read our before you install guide and about the PowDer Flush method.
If your heat pump is already installed and you are fighting recurring air or pressure problems, ask your engineer whether water quality has been tested. Clean, correctly protected water is the foundation every other fix relies on.
Frequently asked questions
What pressure should my heat pump system be?
It varies by system. Your installer should have told you the normal range; check your handover paperwork.
Why does my system keep needing bleeding?
Repeated air can come from small leaks or from corrosion inside the system. An engineer should investigate.
What is an air separator?
A component that removes small air bubbles from circulating water continuously. Many heat pump systems benefit from one.
Is it safe to top up the pressure myself?
Only if your installer has shown you how. Overfilling can cause the relief valve to discharge.
Talk to PowDer Flush before you fit a heat pump
Planning a heat pump on an older system, or chasing a fault on a recent install? Call PowDer Flush for straightforward advice about cleaning the system first. Read our before you install guide for the full picture.
Related guides
Before You Install
Why an old system should be properly cleaned before a heat pump is connected.
Read moreCold radiators and poor heat
Cold spots, rooms that never reach temperature, and heat output lower than expected.
Read moreNoise, icing and defrost
Humming, rattles, steam clouds and ice build-up on the outdoor unit, and what is normal.
Read more