Looking for the Heat Pump Federation? The Heat Pump Federation has merged into Heat Pump Association UK (HPA UK). This website is independent and is not connected to the Heat Pump Federation or HPA UK. Find out more

Our recommended method

PowDer Flush

PowDer Flush is the professional system cleaning method we recommend before a heat pump retrofit. It is carried out by experienced engineers, and microbore systems are a specialism.

What PowDer Flush is

PowDer Flush is a professional cleaning service for wet central heating systems, focused on removing the sludge, magnetite and debris that build up in older radiators and pipework. Its purpose in the context of this website is simple: to get an existing system clean before a heat pump is connected, so the heat pump starts life with clear pipework and clean water.

The people behind it have around twenty years of experience flushing heating systems in UK homes. That experience is the reason we built this site: we kept seeing heat pumps struggle on systems that had never been properly cleaned.

How it works

Every system is different, so the job starts with an assessment rather than a fixed routine. The engineer looks at pipe sizes, radiator condition, valves and signs of corrosion, and talks to you or your installer about the heat pump plans and timing.

The clean itself works through the system thoroughly, dealing with radiators and circuits rather than relying on a single pass. The aim is to physically remove deposits and carry them out of the system, then leave it with clean water ready for the installer, or refilled and protected as agreed. Your engineer will explain the specific steps for your home on the day and answer any questions.

Because the clean is planned around the heat pump installation, timing matters. Too early and further work on the system can reintroduce debris; too late and the installer's programme is disrupted. We coordinate directly with your installer where that helps.

  • Assessment of pipework, radiators and the heat pump plan.
  • Thorough cleaning focused on removing deposits, not just loosening them.
  • Particular attention to microbore, cold-bottomed radiators and long runs.
  • Clean water and a clear handover for you and your installer.

Microbore systems: a specialism

Microbore pipework, usually 8mm or 10mm, was widely fitted in UK homes. Its narrow bore means even a modest build-up of sludge has a large effect on flow, and it is often hard to clear thoroughly. Because heat pumps rely on good flow, dirty microbore is a frequent cause of low flow errors and cold radiators.

Microbore cleaning is a PowDer Flush specialism. Whether microbore is suitable for your heat pump design is a question for your installer, but if it is being kept, it needs to be clean.

Our view on chemical-only flushing

Chemical cleaners have their place, and inhibitors are important for protecting clean water. Our professional view, based on experience rather than laboratory testing, is that chemical-only flushing often leaves deposits behind on older and heavily sludged systems, particularly microbore. A physical clean that removes debris from the system gives a more dependable starting point for a heat pump.

Who it is for

PowDer Flush works with homeowners preparing for a heat pump, installers who want systems cleaned before they connect, and households with existing heat pumps suffering water-related faults. Installers can also refer jobs through our referral scheme. Read the before you install guide for the wider picture.

If you are not sure whether your system needs a clean, a short phone call is usually enough to work out the next step.

Frequently asked questions

How long does a PowDer Flush take?

It depends on the size and condition of the system. The engineer will give you an idea after assessing it.

Will it fix an existing heat pump fault?

If the fault is caused by dirty water or blockages, cleaning can help. Faults in the heat pump itself need the installer or manufacturer.

Do I need PowDer Flush if my installer cleans the system?

Ask them what method they use. If you are unsure it is thorough enough, especially with microbore, call us to talk it through.

Talk to PowDer Flush

Call to discuss your system, whether it has microbore pipework, and when the clean should happen relative to your heat pump installation.

Call 07418 608497